AMF 110 Specifikace stáhnout pdf (Strana 164)

AMF Introduction and Configuration

158 New and Enhanced Features in AlliedWare Plus 5.4.4 Major and Minor Versions

Table 9: Procedure for cloning a provisioned node and configuring its adjacent nodes

Connecting a

provisioned node

to an AMF network

When you add the new node to the AMF network, its settings and files are automatically

downloaded from the master node’s backup media, or a remote backup server, to the new

node’s Flash. All you need to do is cable the new device into the network.

The switch’s port LEDs will flash to show that its settings are being loaded. Progressive

strobing of all the port LEDs indicates that a recovery is underway. For more information

on the node recovery LEDs see “Recovery progress indication” on page 145.

Step g. Configure the port

node(s) that will be

connected to the

provisioned node. In this

example, port1.0.3 on

member4 is being

configured as an AMF

link and to expect the

provisioned node

future_node

Member_4#configure terminal

Member_4(config)#interface port1.0.3

Member_4(config-if)#switchport atmf-link

Member_4(config-if)#switchport trunk native vlan none

Member_4(config-if)#atmf provision future_node

Member_4(config-if)#exit

Member_4(config)#exit

Member_4#atmf working-set group local

Note that AMF links and crosslinks do not need to be configured with data

VLANs and can be used solely to provide AMF management VLAN

redundancy.

Step g can be repeated to configure the ports on other adjacent nodes that

will be connected to the provisioned node.

Step a. Enter Privileged Exec

mode

AMF_Master1>enable

Step b. Set the name of the

provisioned node to

“future_node”. In this

example, the

provisioned node will be

a clone of member_3

AMF_Master1#atmf provision node future_node clone member_3

If further changes are required, follow the commands shown in Step c in

Table 8 above.

Step c. Configure the port

node(s) that will be

connected to the

provisioned node. In this

example, port1.0.3 on

member_4 is being

configured as an AMF

link and to expect the

provisioned node

future_node

AMF_Master1#atmf working-set member_4

member_4#configure terminal

member_4(config)#interface port1.0.3

member_4(config-if)#switchport atmf-link

member_4(config-if)#switchport trunk native vlan none

member_4(config-if)#atmf provision future_node

member_4(config-if)#exit

member_4(config)#exit

member_4#atmf working-set group local

AMF_Master1#

Note that AMF links and crosslinks do not need to be configured with data

VLANs and can be used solely to provide AMF management VLAN

redundancy.

Step c can be repeated to configure the ports on other adjacent nodes to

expect the provisioned node.

1 2 ... 159 160 161 162 163 164 165 166 167 168 169 ... 301 302

Komentáře k této Příručce

Žádné komentáře

AMF 110 Specifikace Strana 164

Komentáře k této Příručce

Související produkty a manuály pro Jízdní kola AMF 110