AMF 110 Specifikace stáhnout pdf (Strana 220)

AMF Commands

214 New and Enhanced Features in AlliedWare Plus 5.4.4 Major and Minor Versions

debug atmf packet

This command configures AMF Packet debugging parameters. The debug only displays

information relevant to the current node. The command has following parameters:

Syntax debug atmf packet[[direction {rx|tx|both}][level {1|2|3}][timeout

<seconds>][num-pkts <quantity>][filter node <name> ][interface

<ifname>][pkt-type {[1][2][3][4][5][6][7][8][9][10][11]]]

Simplified Syntax

Default Level 1, both Tx and Rx, a timeout of 60 seconds with no filters applied.

Mode User Exec and Global Configuration

Usage If no additional parameters are specified, then the command output will apply a default

selection of parameters shown below:

debug atmf packet [direction {rx|tx|both}]

[level {[1][2|3}]

[timeout <seconds>]

[num-pkts <quantity>]

debug atmf packet filter [node <name>]

[interface <ifname>]

[pkt-type [1][2][3][4][5][6][7][8][9][10][11]]

Note

You can combine the syntax components shown, but when doing so, you

must retain their original order.

Note

An alias to the no variant of this command - undebug atmf - can be found

elsewhere in this chapter.

Parameter Description

direction Sets debug to packet received, transmitted, or both

rx packets received by this node

Packets sent from this node

1 AMF Packet Control header Information, Packet Sequence

Number. Enter 1 to select this level.

AMF Detailed Packet Information. Enter 2 to select this level.

3 AMF Packet HEX dump. Enter 3 to select this level.

timeout Sets the execution timeout for packet logging

<seconds> Seconds

num-pkts Sets the number of packets to be dumped

1 2 ... 215 216 217 218 219 220 221 222 223 224 225 ... 301 302

Žádné komentáře

AMF 110 Specifikace Strana 220